The AVF roller blind is a new product in the range offered by Kronmat Sp. z o.o.. It constitutes an ideal accessory for roof windows produced by Velux, meeting all the requirements for internal accessories.
The AVF roller blind is equipped with side guides which cover the space between the blind fabric and window sash, thus making it possible to achieve blackout in the room. The applied system of strings enables parallel guiding the lower slat and setting it in any position, which translates into a possibility of gradual reduction of incoming light. The lower aluminium slat is equipped with a seal for better adherence to the lower section of the sash and limited intrusion of light between the bottom slat and sash. The material (fabric) used in AVF blinds is opaque.
progressive reduction of incoming light (does not offer complete blackout)
reduction of excessive heat in the room | |
ease of use thanks to manual operating and a possibility of setting the blind anywhere up the window | |
reduction of heat loss in the winter | |
protection of the interior from harmful UV radiation | |
ensured feeling of privacy with fully lowered blind |
AVF - 229 | navy blue | |
AVF - 230 | beige |
|
|
The AVF blinds are intended for the following Velux roof windows:
For the correct selection of accessories to fit Velux roof windows, it is necessary to provide the type and size of the window. This information can be found on a data plate situated in the upper right corner of the sash.
The AVF roller blind is available in a manual version operated by means of the lower slat. If the blind is installed outside user’s direct reach, a telescopic rod can be used.
At the same time, we wish to inform that all internal accessories (including AVF) are not subject to CE marking as pursuant to the act on construction products of 16 April 2004 (Journal of Laws No. 92, item 881) internal accessories (roller blinds, Venetian blinds) are not construction products as they were not included in the scope of any of EU mandates for preparation of harmonised standards or guidelines for drafting European technical approvals. Hence, when introducing internal accessories to the market, it is not obligatory to mark them with CE sign or issue European declarations of conformity. Products which are not subject to CE marking must comply with safety requirements specified in the act of 12 December 2003 on general product safety (Journal of Laws, No. 229, item 2275).